| Tailgate Latch Releases But Tailgate Does Not Open |
- Tailgate Set/Alignment
- Obstacle Detection/Pop And Stop
- Mechanical Obstruction
- Low Battery Voltage
- Switch Failure
- Tailgate Latch Does Not Release
- No Electrical Connection/Can
Bus Communication
- Tailgate Strut Internal Failure
|
- Check The Tailgate Alignment To Body, Making Sure That The Values Are With In Service Information Limits, Check Torque For All Hinge Bolt Connections Refer To: Tailgate Alignment
- Check That The Tailgate Isn't Contacting Anything, Specifically The Lower Seal And Interior Trim, Listen For Rear Gate/Trunk Module (Rgtm) Beeps (3 Determines An Obstruction). Try To Aid Opening By Releasing And Pulling The Tailgate Past Obstacle
- Check And Clear Any Mechanical Obstructions
- Check The Battery Voltage - The Tailgate Will Not Power Open With Low Power Warning Present - 'low Battery' Warning Indicator In The Vehicle Instrument Panel Cluster Control Module (Ipc)
- Go To pinpoint Test B .
|
| Tailgate Latch Releases And Lifts But Does Not Open Fully |
- Pre Programed Garage Height Reached
- Tailgate Set/Alignment
- Obstacle Detection
- Mechanical Obstruction
- Low Battery Voltage
- Switch Failure
- Tailgate Strut Internal Failure
|
- Complete Garage Height Set Procedure At Uppermost Height
- Check The Tailgate Alignment To Body, Making Sure That The Values Are With In Service Information Limits, Check Torque For All Hinge Bolt Connections Refer To: Tailgate Alignment
- Listen For Rgtm
Beep Signal (3 Determines An Obstruction)
- Check And Clear Any Mechanical Obstructions, Check Hinge Is Free Moving
- Check The Battery Voltage - The Tailgate Will Not Power Open With Low Power Warning Present - 'low Battery' Warning Indicator In The Vehicle Ipc
- Go To pinpoint Test B .
|
| Tailgate Is In Open State But Does Not Move When Close Requested |
- Tailgate Set/Alignment - Struts Have Not Met Hall Count Target While Opening (Unknown Position)
- Anti-Trap Sensor Failure
- Mechanical Obstruction
- Latch Incorrect State
- Switch Failure
- No Electrical Connection/Can
Bus Communication
- Tailgate Strut Internal Failure
|
- Check The Tailgate Alignment To Body, Making Sure That The Values Are With In Service Information Limits, Check Torque For All Hinge Bolt Connections Refer To: Tailgate Alignment
- Listen For Rgtm
Beep Signal (3 Determines An Obstruction), Inspect For Damage To Anti-Trap Trim Contact
- Check And Clear Any Mechanical Obstructions, Check Hinge Is Free Moving
- Go To pinpoint Test B .
|
| Tailgate Starts To Close But Does Not Reach Latch |
- Anti-Trap Sensor Triggered
- Tailgate Set/Alignment
- Mechanical Obstruction
|
- Listen For Rgtm
Beep Signal (3 Determines An Obstruction), Inspect For Damage To Anti-Trap Trim Contact
- Check The Tailgate Alignment To Body, Making Sure That The Values Are With In Service Information Limits, Check Torque For All Hinge Bolt Connections Refer To: Tailgate Alignment
- Check And Clear Any Mechanical Obstructions, Check Hinge Is Free Moving
- Go To pinpoint Test I .
|
| Open Tailgate Requested But Latch Does Not Release |
- Mechanical Obstruction
- Key Not Detected
- Body Control Module (Bcm) Not Releasing Latch
- Soft Close Actuator Malfunction
- Latch Mechanical Issue
|
|
| Latch Does Not Clasp |
- Key Detected In Boot (Latch Closes Then Opens Again With Horn Chirp)
- Mechanical Obstruction
- Tailgate Set/Alignment
- Latch Incorrect State (Latch Partial Clasp)
- Latch Mechanical Issue
|
- Check For Key In Loadspace Area, Issue Only Present When Single Point Entry Is Active On The Vehicle
- Check And Clear Any Mechanical Obstructions, Making Sure Bump Stops Are Correctly Adjusted
- Check The Tailgate Alignment To Body, Making That The Values Are With In Service Information Limits, Check Torque For All Hinge Bolt Connections Refer To: Tailgate Alignment
- Check Latch Is In Open State Prior To Closing
- Go To pinpoint Test B .
|
| Latch Does Not Soft Close (Power Latch) |
- Key Detected In Boot Or Vehicle (Latch Closes Then Opens Again With Horn Chirp)
- Mechanical Obstruction
- Tailgate Set/Alignment
- Soft Close Actuator Mechanical Issue
- Initial Latch State Not Met - Has Not Closed To First Clasp (Latch Open)
- Latch Mechanical Issue
- Latch Incorrect State (Closing When In First Clasp State)
|
- Check For Key In Loadspace Area, Issue Only Present When Single Point Entry Is Active On The Vehicle
- Check And Clear Any Mechanical Obstructions, Making Sure Bump Stops Are Correctly Adjusted
- Check The Tailgate Alignment To Body, Making Sure That The Values Are With In Service Information Limits, Check Torque For All Hinge Bolt Connections Refer To: Tailgate Alignment
- Check The Mechanical And Electrical Operation Of The Soft Close Actuator Including Bowden Cable Condition Go To pinpoint Test E .
- Check Switch Readout Status Go To pinpoint Test C .
- Check Latch Is In Open State Prior To Closing
- Go To pinpoint Test B .
|
| Hands-Free Tailgate Does Not Open/Close |
- Feature Not Installed
- Incorrect Motion By User
- Incorrect Location For Motion
- Hands-Free Tailgate Sensor Obstructed (By Mud, Snow)
- Key Not Detected
- Sensor Disconnected
- Sensor Issue/Electrical Circuit
|
- Check Vehicle Specification
- Make Sure That User Is Aware Of Correct Operation As Illustrated In The Jaguar Land Rovers Owner's Information
- Make Sure That User Is Aware Of Correct Location As Illustrated In The Jaguar Land Rovers Owner's Information (Either Side Of The Vehicle, Not The Rear)
- Complete Passive Entry Checks Refer To: Locks, Latches And Entry Systems
- Make Sure The Sensor Is Correctly Installed And Check The Integrity Of The Connectors
- Go To pinpoint Test L .
|
| Tailgate Opens Or Closes Inadvertently (And Indicators Flash If Engine Not Running) |
- Gesture Surrounding Components Insufficiently/Intermittently Earthed (Heat Shields)
- Heavy Rain Or Washing The Car When The Key Is Present In The Rear Zone Of The Vehicle
- Incorrect Routing Of Sensor Wires
|
- Check Ground Of Metallic Surrounding Components, Specifically The Heat Shields Making Sure All Fixings Are Present
- Make Sure The User Is Aware Of System Behaviors As Illustrated In The Jaguar Land Rovers Owner's Information
- Check Sensor Wire Orientation And Installation Is As Per Service Information
- Check Sensors Are Correctly Attached
- Go To pinpoint Test M .
|
| Tailgate Does Not Open Or Close From Instrument Panel Switch, All Other Features Work Correctly |
- Electrical Fault Between Tailgate Open Switch - Instrument Panel And Bcm
|
- Check For Related Dtc
And Refer To The Relevant Dtc
Index
- Complete Electrical Checks For Instrument Panel Tailgate Switch
- Go To pinpoint Test C .
|
| Tailgate Does Not Open Or Close From Smart Key, All Other Features Work Correctly |
- Electrical Fault Between Tailgate Open Switch - Remote Function Actuator (Rfa) And Bcm
- Rfa
Internal Failure
|
- Refer To The Appropriate Service Information
.
|
Tailgate Surface Cracking Visible On The Inside Of The Tailgate Hinge Area
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
|
- Cracking May Be Caused By Over-Extension Of The Tailgate And The Resultant Stress Forces On The Tailgate Hinge Assembly
|
|
Tailgate Latch Scuffing Visible On The Inside Of The Tailgate Latch Area
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
|
- Latch Scuffing May Be Caused By A Misaligned Tailgate Latch
|
|