Symptom Chart

Symptom	Possible Cause	Action
Misty/foggy/blurry image displayed on the touchscreen when operating the rear view camera, limiting visibility when maneuvering the vehicle	Evidence of water ingress/oxidation/corrosion on camera housing	Install a new rear view camera Refer to: REAR PARKING AID CAMERA
Rear view camera image slow to react	System operation within specification	NOTE: After selecting reverse, it may take up to 2 seconds for the image to be displayed No further action necessary
Blank screen	Rear view camera not functioning	GO to PINPOINT TEST A .
Camera system unavailable	Video in signal absent	GO to PINPOINT TEST B .
No tracking lines	Missing/invalid reverse gear signal Camera control module Flexray fault Rear view camera Controller Area Network (CAN) fault	Using the Jaguar Land Rover approved diagnostic equipment, check the camera control module and rear view camera for related DTC s and refer to the relevant DTC index GO to PINPOINT TEST C .
Frozen tracking lines	Camera control module Flexray fault Rear view camera CAN fault	GO to PINPOINT TEST D .