Tie-Rod (G2312534): Installation

- Install the tie-rod.
- Renew the tie-rod to subframe nut.
  Renew Part: Tie-rod end locking nut Quantity: 1 .
- Renew the tie-rod to wheel knuckle nut and bolt.
  Renew Part: Tie-rod nut and bolt Quantity: 1 .
- Check the alignment of the adjustment bolt.
- Tighten the adjustment bolt.
  Torque
  
  Stage 1: 70 Nm
  
  Stage 2: 60°
CAUTION: Torque must be applied to the bolt.
- Tighten the tie-rod to wheel knuckle nut and bolt.
  Torque
  
  Stage 1: 60 Nm
  
  Stage 2: 180°
NOTE: This step applies to the left bolt only.

Install the fuel tank.

Refer to: FUEL TANK .
Use the Jaguar Land Rover approved equipment to check and if necessary adjust the rear wheel alignment. SRO must be claimed separately.