Side Air Curtain (G2301161): Installation
-
NOTE: This step requires the aid of another technician.
- Position the side air curtain above the door aperture.
- Align and install the 2 center side air curtain locators to the holes on the body side.
- Install the bolt.
-
CAUTION:
- Make sure the side air curtain metal clips engaged properly.
- Make sure the side air curtain is untwisted.
- Make sure the side air curtain front tether is untwisted.
- Align and install the anti-rotation tab to the hole on the A-pillar.
- Install the front bolt.
- Install the 3 side air curtain metal clips. Progress from the center of the side air curtain towards front.
-
CAUTION: Make sure the side air curtain metal clips engaged properly.
- Align and install the anti-rotation tab to the hole on body side.
- Install the rear bolt.
- Tighten the 3 bolts.
Torque : 10 Nm
- Install the 2 side air curtain metal clips. Progress from the center of the side air curtain towards rear.
-
CAUTION: Make sure the side air curtain electrical connector connected properly.
Connect the side air curtain electrical connector.
-
- Install the bracket.
- Install and tighten the 2 bolts.
Torque : 10 Nm
- Install the headliner.
Refer to: HEADLINER .
- Connect the startup battery ground cable.
Refer to: 12V SYSTEM DISCONNECT .
- If a new component has been installed, configure using Jaguar Land Rover (JLR) approved diagnostic equipment.
General Equipment: Jaguar Land Rover approved diagnostic equipment