LEMON Manuals: Even more car manuals for everyone
Home >> Land Rover >> 2022 >> Range Rover Evoque SE >> Repair and Diagnosis >> Restraints >> Air Bag, SRS >> Supplemental Restraint System -- Range Rover EVOQUE/L551 >> Supplementary Restraint System >> General Procedures >> Airbag Disposal (G928274) >> Disposal Of Live Airbag Modules For Driver Airbag Module, Passenger Airbag Module And Side Airbag Modules, Using Tires

Disposal Of Live Airbag Modules For Driver Airbag Module, Passenger Airbag Module And Side Airbag Modules, Using Tires

  1. Equipment required: Deployment tool 418-S135, 12 V power source, Safety goggles to BS2092 grade 2, Rubber gloves to PrEN 374 class 2, Ear protectors that have been measured to BS. EN 24869, Particulate respirator to EN 149 grade FFP2S.
  2. The deployment procedure must be completed outdoors, away from other personnel.
  3. WARNING: Make sure that the tire stack is stable before and after deployment. Failure to follow this instruction my result in personal injury.

    Stack four scrap tires, securing together with heavy gauge wire or cable. While disconnected from any electrical power source, connect deployment harness and place airbag adapter portion under tire stack, ready for connection to airbag.

  4. WARNING: 12 V power source must not be connected during this step. Failure to follow this instruction may result in personal injury.
    CAUTION: Make sure the connector is not in contact with the inflator or it will be damaged during the test.

    Connect airbag to airbag connector, make sure the locking sleeve is fully engaged. Position the airbag with the cover facing upwards.

  5. Make sure the 12 V power source connections of deployment harness are ten meters away from the tire stack
  6. Remove any loose debris from around the airbag. Make sure that no flammable liquids are present.
  7. WARNING: Before proceeding, make sure precautions have been taken to warn personnel of a possible loud noise upon activation. Do not allow anybody to approach closer to restraint device than 6.1 meters (20 feet). Failure to follow this instruction may result in personal injury.

    Move as far from restraint device as possible and connect the tool clips to a 12 V power source.

  8. WARNING: Do not handle the deployed device immediately after activation, as it may be hot. Allow the unit to cool for at least 20 minutes. Cooling modules should be continuously monitored to make sure heat does not create a fire with spilled liquids or other debris. Failure to follow this instruction may result in personal injury.

    Deploy the module by depressing both switches on the tool. If activation does not occur, disconnect the 12 V power source from tool and seek advise from JLR  engineering and wait for further instructions.

  9. Remove the airbag from the tire stack and seal in a plastic bag, ready for disposal.
  10. In the event of any problems or queries arising from this procedure, contact JLR  engineering.
scientia non olet · About LEMON Manuals