Airbag Warning Light on and DTC(s) B0001-13 set

If the airbag warning light is on with DTC(s)  B0001-13 set, follow the steps below.

1. Using the Jaguar Land Rover approved diagnostic equipment, check, and update the RCM  with the latest level of software. Clear the Diagnostic Trouble Code(s) and retest
2. Turn on the ignition, check the airbag warning light disappears. Observe the instrument cluster for at least 15 seconds to make sure the airbag warning light does not re-appear. Using the Jaguar Land Rover approved diagnostic equipment, check B0001-13 has not returned
3. Remove the driver airbag from the steering wheel

   Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

   NOTE: DO NOT  disconnect the driver airbag connector from the driver airbag (Connector number 2 as shown in the image above)
4. Disconnect the driver airbag connector from the clockspring (Connector number one as shown in the image above)

   Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

   NOTE:

   • No more than 0.2g is to applied to the connector, 0.1g per pin
   • Pins 1 and 2 of the driver airbag connector are highlighted on the circuit diagram image above for clarity
5. Apply Nyogel 760G to the connector pins
6. Install the driver airbag to the steering wheel
7. Using the Jaguar Land Rover approved diagnostic equipment, clear the DTC(s)  and retest
8. If the fault persists or the vehicle has been returned with repeat symptoms, install a new clockspring and driver airbag making sure to apply nyogel as noted in step 3