LEMON Manuals: Even more car manuals for everyone
Home >> Land Rover >> 2022 >> Range Rover Evoque SE >> Repair and Diagnosis >> Engine Performance >> Tune-Up >> Engine Ignition - INGENIUM I4 2.0L Petrol -- Range Rover EVOQUE/L551 >> Engine Ignition - INGENIUM I4 2.0L Petrol >> Removal And Installation >> Spark Plugs (G2299463) >> Installation

Spark Plugs (G2299463): Installation

  1. NOTE: Clean all the mating faces and reusable parts thoroughly and check for damage.

    Check the spark plug gap, refer to specifications.

  2. WARNING: Make sure that the spark plug ceramic insulator and terminal pin are wiped/cleaned dry using a soft clean cloth.
    CAUTION: Following installation of the spark plugs in the cylinder head visually inspect the paint mark on the terminal of the spark plug for correct orientation. The head of the T paint mark must face the Injector within ± 45°.

    Using the special tool, install the spark plugs.

    Special Tool(s): 303-1450 

    Torque  : 23 Nm 

  3. WARNING: Make sure that the ignition coil rubber boot is pushed down fully over the spark plug insulator ceramic. Double check by installing the ignition coil as usual and then pushing on the ignition coil head gently for a second time to make sure that the ignition coil rubber boot has seated correctly over the spark plug insulator.
    • Install the ignition coil-on-plugs.
    • Install and tighten the bolts.

      Torque  : 8 Nm 

    • Connect the electrical connectors.
  4. Connect the electrical connector.
  5. Install the engine cover.

    Refer to: ENGINE COVER - INGENIUM I4 2.0L PETROL .

scientia non olet · About LEMON Manuals