Instrument Cluster (G2301125): Installation

- Connect the 3 electrical connectors.
- Secure the wiring harness to the 4 clips.
- Install the instrument cluster.
- Install and tighten the 4 screws.
  Torque : 5 Nm
- Install the instrument cluster upper trim panel.
- Secure the 2 clips.
- Install the instrument cluster lower trim panel.
- Secure the 2 plastic retainers.
- Install and tighten the 3 screws.
  Torque : 2 Nm
- Install the access cover.
- Install the trim panel.
- Secure the 4 clips.
- Install the steering column upper trim panel.
- Secure the 2 clips.
- Connect the 2 electrical connector.
- Install the steering column lower trim panel.
- Secure the 7 clips.
- Install and tighten the 2 bolts.
  Torque : 5 Nm
Install the driver side vent.
Refer to: DRIVER SIDE VENT .
CAUTION: Only applicable vehicles with software numbers K8D2-14C104-AC or L8B2-14C104-AC as detailed in removal step 1 .
NOTE:
- Only complete this step if a new instrument cluster is to be installed.
- Non-NAS Markets only.
- SRO must be claimed separately.
- All keys need to be present for the RFA replacement.
Install a new RFA .

Refer to: REMOTE FUNCTION ACTUATOR .
Connect the startup battery ground cable.
Refer to: 12V SYSTEM DISCONNECT .
If a new component has been installed, configure using Land Rover approved diagnostic equipment.
General Equipment: Land Rover diagnostic equipment