LEMON Manuals: Even more car manuals for everyone
Home >> Land Rover >> 2022 >> Range Rover Evoque SE >> Repair and Diagnosis >> Drivelines & Axles >> Differentials & Drive Axles >> Rear Drive Axle/Differential Vehicles With MHEV/Non Electric Vehicles -- Range Rover EVOQUE/L551 >> Rear Drive Axle/Differential - Vehicles With: MHEV/Non-Electric Vehicles (G2320433) >> Removal And Installation >> Rear Differential Control Module (G2309516) >> Installation

Rear Differential Control Module (G2309516): Installation

    • Install the Rear Drive Unit (RDU) control module.
    • Install the 2 upper bolts finger tight.
    • Install the 2 lower bolts finger tight.
    • Fully tighten the 2 lower bolts.

      Torque  : 10 Nm 

    • Fully tighten the 2 upper bolts.

      Torque  : 10 Nm 

  2. Connect the 2 RDU control module electrical connectors.
  3. Install the wiring harness clip.
  4. If a new component has been installed, configure using the Jaguar Land Rover (JLR) approved diagnostic equipment.

    General Equipment: Jaguar Land Rover approved diagnostic equipment 

scientia non olet · About LEMON Manuals