Rear HALFSHAFT (G2305910): Removal
CAUTION:
- Do not touch the gaiter and when handling the halfshaft make sure that the gaiters does not touch any sharp component or object.
- When handling the halfshaft, do not articulate the Constant Velocity joint (CV). Failure to follow this instruction may result in damage to the CV and gaiter.
- Before disconnecting any components, make sure the area is clean and free from foreign material. When disconnected all openings must be sealed.
NOTE:
- This procedure contains some variation in the illustrations depending on the vehicle specification, but the essential information is always correct.
- This procedure contains illustrations showing certain components removed to provide extra clarity.
- This procedure contains illustrations for right side components, left side components are similar.
The following step(s) applies to:
All vehicles
- Raise and support the vehicle on a suitable 2 post lift.
Refer to: JACKING AND LIFTING .
- Remove the rear wheel knuckle.
Refer to: WHEEL KNUCKLE .
The following step(s) applies to:
Non plug in hybrid electric vehicles only
-
NOTE:
- Do not pull on the halfshaft between the CV as this will damage the inner CV .
- Keep the halfshaft horizontal to avoid damaging the rear halfshaft seal.
- Remove the rear halfshaft from the rear differential.
- Examine the halfshaft seal for wear and replace if damaged.
The following step(s) applies to:
Plug in hybrid electric vehicles only
-
CAUTION:
- Take extra care not to damage the rear halfshaft seal.
- Make sure the bar is correctly located on the halfshaft as illustrated, failure to follow this instruction could result in damage to the halfshaft.
Use a suitable bar and hammer to shock the rear halfshaft.
-
NOTE:
- Do not pull on the halfshaft between the CV as this will damage the inner CV .
- Keep the halfshaft horizontal to avoid damaging the rear halfshaft seal.
- Remove the rear halfshaft from the rear differential.
- Examine the halfshaft seal for wear and replace if damaged.
The following step(s) applies to:
All vehicles
Remove and discard the circlip.