Electric Park Brake Actuator (G2319503): Removal
NOTE:
- This procedure contains illustrations showing certain components removed to provide extra clarity.
- This procedure contains some variation in the illustration depending on the vehicle specification, but essential information is always correct.
- Connect the Jaguar Land Rover (JLR) approved diagnostic equipment and set Electric Park Brake (EPB) to the maintenance position.
General Equipment: Jaguar Land Rover approved diagnostic equipment
-
NOTE: This step is only required if the diagnostic equipment is not available.
Activate the service mode of the EPB.
Refer to: ELECTRIC PARK BRAKE SERVICE MODE ACTIVATION AND DEACTIVATION .
- Raise and support the vehicle on a suitable 2 post lift.
Refer to: JACKING AND LIFTING .
- Remove the wheel and tire.
Refer to: WHEEL AND TIRE .
- Disconnect the brake pad wear sensor.
- Disconnect the EPB electrical connector.
- Remove the bolt and release the wiring harness.
- Remove the 2 bolts.
- Remove the EPB actuator.
- Remove and discard the O-ring seal.