LEMON Manuals: Even more car manuals for everyone
Home >> Land Rover >> 2022 >> Range Rover Evoque SE >> Repair and Diagnosis >> Brakes >> Parking Brake System >> Parking Brake And Actuation -- Range Rover EVOQUE/L551 >> Parking Brake And Actuation >> General Procedures >> Electric Park Brake Service Mode Activation And Deactivation (G1785115) >> Activation

Electric Park Brake Service Mode Activation And Deactivation (G1785115): Activation

CAUTION:
  • The electric park brake (EPB) switch apply/release is inhibited while in this mode (for safety of technicians fingers) so do not drive the vehicle in this condition. Failure to follow this instruction may cause personal injury.
  • This procedure requires the vehicle in the Park or Neutral position, with the ignition turned ON (the engine must be OFF) and the parking brake system released.
  • Once the rear brake pads or brake discs have been installed, the Service Mode must be cancelled.
NOTE: This procedure allows the parking brake to be released when removing and installing new rear brake pads or brake discs.
  1. Press and hold the parking brake switch in the release position.
  2. Wait one second.
  3. Press and hold the accelerator pedal in the wide open throttle position.
  4. Wait one second.
  5. Switch the ignition OFF and back ON immediately.
    NOTE: An audible noise will be heard to confirm that the parking brake has been released in Service Mode.
  6. Release the accelerator pedal and release the parking brake switch to the neutral position.
scientia non olet · About LEMON Manuals