Electric Park Brake Release When The Vehicle Has No Electrical Power (G1785116): Adjustment

- Install a new O-ring seal.
  Renew Part: Electric park brake actuator fitting kit Quantity: 2 .
- Install the Electric Park Brake (EPB) actuator to the brake caliper.
- Install and tighten the 2 new bolts.
  Torque : 11 Nm
- Install the brake pad wear sensor.
- Connect the electrical connector.
- Install the wiring harness bracket.
- Install and tighten the bolt.
  Torque : 8 Nm
Install both the rear wheels and tires.
Refer to: WHEEL AND TIRE .
Connect the startup battery ground cable.
Refer to: 12V SYSTEM DISCONNECT .
Using the Jaguar Land Rover approved diagnostic equipment, calibrate the EPB.
General Equipment: Jaguar Land Rover approved diagnostic equipment