Roof Blind Reset
The roof blind needs to be reset if the startup battery is disconnected, becomes discharged, or the power supply is interrupted.
The following conditions must be met before running the roof opening panel reset procedure:
- The ambient temperature is within the range of 5°C (41°F) to 65°C (149°F).
- The vehicle is stationary.
- The startup battery of the vehicle is sufficiently charged and the electrical connections are good.
WARNING:
The anti-trap system is disabled during the reset cycle. Make sure that no occupants have any part of their body in a position where it could be trapped.
When the power supply is restored, reset the roof mechanism as follows:
- Switch the ignition ON (Power Mode 6).
- Close the roof blind and then release the switch.
- Fully press and hold the front of the roof blind switch for about 30 seconds, until an audible double click sounds.
- Release the switch. Within 3 seconds, press and hold the roof blind switch again. Hold the switch until the roof blind completes a full open and close cycle.
- When the roof blind has stopped moving, release the switch. The roof blind is now fully initialized.