Side Parking Aid Camera (G1780357): Installation

To install, reverse the removal procedure.
- Following the replacement of a camera on these vehicles the calibration process is:
- Drive the vehicle for 5 to 10 minutes as much as possible in a straight line, up to 30kph/19mph, during this time the camera will self-calibrate (do not have the camera functions turned on) to be carried out in normal daylight conditions.
- After completing the drive cycle camera operation can be checked by:
- Surround View Camera: To check calibration parked next to a curb/line select camera view make sure a straight line is visible on screen in the 360 plan view
- Standalone Rear Camera To check calibration reverse straight into a marked parking slot and see trajectory overlays are parallel to the markings on the ground