Parking Aid Camera Module (G2309681): Installation

- Install the parking aid camera module.
- Install the 2 nuts.
  Torque : 10 Nm
- Connect the 6 electrical connectors.
- Install the support bracket.
- Install the 4 retainers.
  Torque : 8 Nm
Install the rear floor carpet.
- Install the front floor carpet.
- Install the 2 clips.
Install the front left treadplate.
Refer to: FRONT LEFT TREADPLATE .
Install the front row seat.
Refer to: FRONT ROW SEAT .
If a new module is installed, configure using the Jaguar Land Rover approved diagnostic equipment.
General Equipment: Jaguar Land Rover approved diagnostic equipment