Front Row Seat SWITCHPACK (G2308080): Removal

WARNING:

To prevent accidental deployment, you must de-energize the power in the Restraints Control Module (RCM). Wait at least 2 minutes after you disconnect the startup battery ground cable before you do any work on, or adjacent to, the Supplementary Restraint System (SRS). If you do not follow these instructions, it can cause injury or death.
Always wear safety glasses when working on an airbag equipped vehicle and when handling an airbag. Failure to follow this instruction may result in personal injury.
Do not connect any electrical test device or equipment to the Supplementary Restraint System (SRS) connectors.

NOTE:

This procedure contains some variation in the illustrations depending on the vehicle specification, but the essential information is always correct.
This procedure contains illustrations showing certain components removed to provide extra clarity.

Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Move the front row seat forward.
Disconnect the startup battery ground cable.
Refer to: SPECIFICATIONS .
To avoid accidental deployment, wait at least 2 minutes after you disconnect the startup battery ground cable.
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Remove the front row seat outer trim.
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
- Disconnect the front row seatbelt pretensioner electrical connector.
- Remove and discard the bolt.
- Release the front row seatbelt pretensioner.
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
- Release the front row seat outer valance in the sequence shown.
- Disconnect the front row seat switchpack electrical connector.
- Remove the front row seat outer valance.
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
- Remove the 4 screws.
- Remove the front row seat switchpack.