LEMON Manuals: Even more car manuals for everyone
Home >> Land Rover >> 2022 >> Range Rover Evoque SE >> Repair and Diagnosis >> Accessories & Equipment >> Seats >> Seating -- Range Rover EVOQUE/L551 >> Seating >> Diagnosis And Testing >> Seats - Vehicles With: Climate Controlled Seats (G1937887) >> Pinpoint Tests >> Pinpoint Test A: Heater And Cooling - Seat Backrest And Base Inoperative

Pinpoint Test A: Heater And Cooling - Seat Backrest And Base Inoperative

  1. A1: CONFIRM CLIMATE SEATING IS INSTALLED 
    1. Check the vehicle specification and confirm that climate seats (heated/cooled) are installed to the vehicle

      Are climate seats (heated/cooled) installed to the vehicle?

      Yes:  GO to  A2.

      No:  No further action required, refer the customer to Jaguar Land Rover owner information and explain that the function is not installed.

  2. A2: CHECK FOR STORED DIAGNOSTIC TROUBLE CODE(S) 
    1. Check the HVAC  for stored DTC  s

      Are there any stored DTC  s?

      Yes:  For information on stored DTC  s refer to the information in the HVAC DTC  index. If the fault persists or the DTC  index refers back to the Diagnosis and Testing procedure, GO to  A3.

      No:  GO to  A3.

  3. A3: DRIVER OR FRONT PASSENGER SEAT BACKREST CLIMATE ASSEMBLY - FUNCTIONALITY CHECK 
    WARNING: Before work is completed, make the airbag supplemental restraint system safe. For additional information, refer to Standard Workshop Practices article before removing components or disconnecting affected seat connectors
    NOTE:
    • The climate controlled seat's (heat and cool) functions will only operate when the vehicle's engine is running
    • The climate controlled seat's (heat and cool) functions may not operate as expected with the battery in a low state of charge
    1. Check the heat and cool function of the seat backrest and the seat base with the vehicle engine running and the battery in a good state of charge

      Does the heat and cool function operate correctly?

      Yes:  No further action required, refer the customer to Jaguar Land Rover owner information for Climate Seats and review the system operation with the customer.

      No:  GO to  A4.

  4. A4: DRIVER OR FRONT PASSENGER SEAT CUSHION CLIMATE ASSEMBLY - CIRCUIT CHECKS 
    1. Refer to the electrical circuit diagrams and check the supply ground circuit and LIN  circuit at the affected climate seat module for short circuit, open circuit or high resistance

      Was a fault identified with any of the circuit checks?

      Yes:  Repair the wiring harness Refer to: WIRING HARNESS OVERLAY . or replace the affected climate seat module as necessary.

      No:  GO to  A5.

  5. A5: DRIVER OR FRONT PASSENGER SEAT CUSHION CLIMATE ASSEMBLY - CIRCUIT CHECKS 
    1. Refer to the electrical circuit diagrams and inspect all of the associated supply ground and LIN  circuit harness connectors and terminals for signs of damage, backed out/loose pins, corrosion and water ingress.

      Was a concern identified with any of the connectors?

      Yes:  Repair the wiring harness/connector as necessary Refer to: WIRING HARNESS OVERLAY .

      No:  GO to  A6.

  6. A6: HVAC CONTROL MODULE SOFTWARE LEVEL CHECK 
    1. Reassemble all of the electrical circuits, using the Jaguar Land Rover approved diagnostic equipment, reconfigure the HVAC  with the latest level software and retest the system.

      Does the system operate as expected?

      Yes:  No further action required, software fault with HVAC 

      No:  GO to  A7.

  7. A7: CAR CONFIGURATION FILE UPDATE 
    1. Using Jaguar Land Rover approved diagnostic equipment, check and update the car configuration file as necessary. Clear the DTC  s and retest

      Does the system operate as expected?

      Yes:  No further action required, Car Configuration File (CCF) fault with HVAC 

      No:  Raise a Technical Assistance (TA) and report all of the above findings and information.

scientia non olet · About LEMON Manuals