Second Row Seats

Control of the second row seat heating is by switches on the rear of the floor console. There are 3 Light Emitting Diodes (LEDs) to indicate the temperature.

The control signal is on the Local Interconnect Network (LIN) bus. The heater elements receive a supply from the Rear Junction Box (RJB).

Each second row seat heater can be operated separately. There is a switch for each seat heater.

To fold the second row seats, operate the relevant latch release assembly located in the loadspace.

The center section of the second row seat can also be released separately by operating the latch release on the top of the center seat.

Make sure there are no obstructions when folding the seats.