Oil Pump - INGENIUM I4 2.0L Petrol - PHEV (G2748111): Installation

NOTE: This step is not required if previously removed.
- Install the oil pickup pipe.
- Install and tighten the 2 bolts.
  Torque : 12 Nm
- Install a new O-ring seal.
  Renew Part: Oil pump seals Quantity: 1 .
- Install the oil pump.
- Install and tighten the 5 bolts.
  Torque : 25 Nm
- Install the wiring harness to the 2 clips.
- Install the oil pump electrical connector to the cylinder block.
- Install the wiring harness to the clip.
Connect the electrical connector.
Install the oil pump drive chain.
Refer to: OIL PUMP DRIVE CHAIN - INGENIUM I4 2.0L PETROL - PHEV
Connect the 12 V system.
Refer to: 12V SYSTEM DISCONNECT AND CONNECT