Crankshaft Rear Seal - INGENIUM I4 2.0L Petrol (G2344451): Installation

CAUTION: Make sure that the area around the component is clean and free of foreign material.

Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Install the special tool.

Special Tool(s): JLR-303-1674A
CAUTION:
- If the seal is removed from the spacer provided, a new seal must be installed.
- Make sure that the area around the component is clean and free of foreign material.
NOTE: The component labeled (2) in the illustration is an alignment spacer provided with the new seal.

Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Position the new crankshaft oil seal (1) and spacer (2) over special tool JLR-303-1674A. Carefully slide the crankshaft oil seal (1) over the end of the crankshaft and discard the spacer (2).

Special Tool(s): JLR-303-1674A

Renew Part: Crankshaft rear seal Quantity: 1 .
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
- Install the second part of special tool JLR-303-1674A to position the crankshaft oil seal correctly.
  Special Tool(s): JLR-303-1674A
- Tighten the bolt until the seal is fully installed and the bolt stops turning.
Install the drive plate.
Refer to: DRIVE PLATE - INGENIUM I4 2.0L PETROL
Connect the startup battery ground cable.
Refer to: 12V SYSTEM DISCONNECT AND CONNECT