LEMON Manuals: Even more car manuals for everyone
Home >> Land Rover >> 2022 >> Defender 90 X >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Fuel Charging And Controls - Turbocharger - INGENIUM 2.0L Petrol/INGENIUM I4 2.0L Petrol - PHEV -- Defender/L663) >> Fuel Charging And Controls - Turbocharger - INGENIUM I4 2.0L Petrol/INGENIUM I4 2.0L Petrol - PHEV (G2748212) >> Removal And Installation >> Oil Supply Pipe (G2401841) >> Removal

Oil Supply Pipe (G2401841): Removal

WARNING: This page is about a different variant/trim than selected.
CAUTION: Before disconnecting any components, make sure the area is clean and free from foreign material. When disconnected all openings must be sealed.
NOTE:
  • This procedure contains some variation in the illustrations depending on the vehicle specification, but the essential information is always correct.
  • This procedure contains illustrations showing certain components removed to provide extra clarity.
  1. Disconnect the startup battery ground cable.

    Refer to: 12V SYSTEM DISCONNECT AND CONNECT

  2. Remove the engine cover.

    Refer to: ENGINE COVER - INGENIUM I4 2.0L PETROL

  3. WARNING: Be prepared to collect escaping oil.
    G12004899Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
    • Remove the bolt.
    • Disconnect the oil supply pipe from the turbocharger.
    • Remove and discard the 2 sealing washers.
  4. WARNING: Be prepared to collect escaping oil.
    G12009398Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
    • Remove the bolt.
    • Remove the oil supply pipe.
    • Remove and discard the 2 sealing washers.
scientia non olet · About LEMON Manuals