LEMON Manuals: Even more car manuals for everyone
Home >> Land Rover >> 2022 >> Defender 90 X-Dynamic SE >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Instrument Cluster -- Defender/L663 >> Instrument Cluster (G2323747) >> Removal And Installation >> Instrument Cluster (G2323748) >> Installation

Instrument Cluster (G2323748): Installation

  1. CAUTION: Take extra care not to damage the component.
    • Connect the 3 electrical connectors to the instrument cluster.
    • Install the instrument cluster.
    • Install the 2 new fasteners.
    • Install and tighten the 4 screws.

      Torque  : 1.7 Nm 

    • Install the steering column upper trim panel.
    • Secure the 8 clips.
    • Install and tighten the 4 screws.

      Torque  : 1.7 Nm 

  2. CAUTION:
    • Make sure the connector is correctly secured.
    • Take extra care not to damage the component.
    • Connect the electrical connector to the ambience lighting wiring harness.
    • Install the instrument cluster upper trim panel to the 6 clips.
    • Install the bracket of the instrument panel center upper tray.
    • Install and tighten the 3 screws.

      Torque  : 1.7 Nm 

    • Connect the electrical connector in-vehicle temperature sensor.
  3. Install the instrument panel center upper tray to the 2 fasteners.
    • Connect the 2 electrical connectors to the 2 switches.
    • Install the trim panel at the 2 clips.
    • Install and tighten the 2 screws.

      Torque  : 0.6 Nm 

    • Install the bracket of the instrument panel left upper tray.
    • Install and tighten the 2 screws and 1 bolt.

      Torque  : 1.7 Nm 

  4. Install the instrument panel left upper tray to the 2 fasteners.
  5. Install the instrument panel lower trim.

    Refer to: DRIVERS INSTRUMENT PANEL LOWER TRIM

  6. CAUTION: Only applicable vehicles with software numbers K8D2-14C104-AC or L8B2-14C104-AC as detailed in removal step 1  .
    NOTE:
    • Only complete this step if a new instrument cluster is to be installed.
    • Non-NAS Markets only.
    • SRO must be claimed separately.
    • All keys need to be present for the RFA  replacement.

    Install a new RFA  .

    Refer to: REMOTE FUNCTION ACTUATOR

  7. Connect the startup battery ground cable.

    Refer to: 12V SYSTEM DISCONNECT AND CONNECT

  8. NOTE: This step is only required if a new component is installed.
    • Use the Land Rover approved diagnostic equipment to configure the new module.

      General Equipment: Land Rover diagnostic equipment 

    • Follow all on-screen instructions to complete this task.