DTC P08AA-12: Clutch Pedal Position Sensor "A" Circuit High - Circuit short to battery: Action
WARNING: This page is about a different variant/trim than selected.
- Vehicle Conditions to enable DTC Logging Strategy
- Ignition on, clutch pressed fully for 5 seconds, clutch released fully for 5 seconds
- Prioritized Checks to Perform
- Refer to the electrical circuit diagrams and check the clutch pedal position sensor circuit(s) for short circuit to power. Repair the wiring harness as necessary
- Inspect connectors for signs of water ingress, and pins for damage and/or corrosion
- Check the mechanical operation of the clutch pedal position sensor
- Using the Jaguar Land Rover approved diagnostic equipment, clear the Diagnostic Trouble Code(s) and retest
- If fault persists, replace the clutch pedal position sensor