Right Differential Pressure Sensor (G2796691): Removal

WARNING: This page is about a different variant/trim than selected.

NOTE:

This procedure contains some variation in the illustrations depending on the vehicle specification, but the essential information is always correct.
This procedure contains illustrations showing certain components removed to provide extra clarity.
If the differential pressure sensor is removed from the exhaust manifold, it must be replaced.

Remove the engine cover.
Refer to: ENGINE COVER - V8 S/C 5.0L PETROL
Remove the right air cleaner.
Refer to: RIGHT AIR CLEANER
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Remove the banjo bolt.
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
- Disconnect the electrical connector.
- Remove the 2 nuts.
- Remove the differential pressure sensor assembly.