Right Differential Pressure Sensor (G2796691): Installation
WARNING: This page is about a different variant/trim than selected.
-
- Install the differential pressure sensor assembly.
- Install and tighten the 2 nuts.
Torque : 9 Nm
- Connect the electrical connector.
- Install and tighten the banjo bolt.
Torque : 50 Nm
- Fully tighten the bracket bolt.
Torque : 9 Nm
- Install and tighten the banjo bolt.
- Install the right air cleaner.
Refer to: RIGHT AIR CLEANER
- Install the engine cover.
Refer to: ENGINE COVER - V8 S/C 5.0L PETROL