LEMON Manuals: Even more car manuals for everyone
Home >> Land Rover >> 2022 >> Defender 90 S >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 7 (Electronic Engine Controls - V8 S/C 5.0L Petrol -- Defender/L663) >> Electronic Engine Controls - V8 S/C 5.0L Petrol (G2796672) >> Removal And Installation >> Right Camshaft Position Sensor (G2796675) >> Installation

Right Camshaft Position Sensor (G2796675): Installation

WARNING: This page is about a different variant/trim than selected.
    • Install the CMP  .
    • Install and tighten the bolt.

      Torque  : 10 Nm 

    • Connect the electrical connector to the CMP  .
    • Install the coolant hose assembly.
    • Connect the 2 coolant pipes to both sides of the charge air cooler.
    • Secure the 2 upper clips.
    • Connect the coolant lower hose to the coolant hose assembly.
    • Secure the 3 hose clamps.
    • Install the clean air duct.
    • Tighten the clamp.
  4. Install the air cleaner outlet pipe t-connector.

    Refer to: AIR CLEANER OUTLET PIPE T-CONNECTOR

  5. Fill the engine coolant system with the correct amount of coolant.

    Refer to: COOLING SYSTEM PARTIAL DRAINING AND VACUUM FILLING

scientia non olet · About LEMON Manuals