Mass Air Flow And Temperature Sensor (G2815897): Installation

WARNING: This page is about a different variant/trim than selected.

- Install the new O-ring seal.
  Renew Part: Mass air flow sensor O-ring seal Quantity: 1 .
- Install the MAFT sensor.
- Install and tighten the 2 screws.
  Torque : 5 Nm
- Connect the electrical connector to the MAFT .
- Install the clean air duct.
- Tighten the 2 clamps.
  Torque : 3.5 Nm
Install the engine cover.
Refer to: ENGINE COVER - V8 S/C 5.0L PETROL