LEMON Manuals: Even more car manuals for everyone
Home >> Land Rover >> 2022 >> Defender 90 S >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 7 (Electronic Engine Controls - V8 S/C 5.0L Petrol -- Defender/L663) >> Electronic Engine Controls - V8 S/C 5.0L Petrol (G2796672) >> Removal And Installation >> Engine Oil Level Sensor (G2796679) >> Removal

Engine Oil Level Sensor (G2796679): Removal

WARNING: This page is about a different variant/trim than selected.
CAUTION:
  • Before disconnecting any components, make sure the area is clean and free from foreign material.
  • The ignition must be set to the OFF position before completing the following procedure.
NOTE:
  • This procedure contains some variation in the illustrations depending on the vehicle specification, but the essential information is always correct.
  • This procedure contains illustrations showing certain components removed to provide extra clarity.
  1. Raise and support the vehicle on a suitable 2 post lift.

    Refer to: JACKING AND LIFTING

  2. Drain the engine oil.

    Refer to: ENGINE OIL VACUUM DRAINING AND FILLING

  3. Remove the engine undershield.

    Refer to: ENGINE UNDERSHIELD

  4. WARNING: Be prepared to collect escaping engine oil.
    G15306837Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
    • Disconnect the electrical connector from the engine oil level sensor.
    • Remove the 3 bolts.
    • Remove the engine oil level sensor.
    • Remove and discard the O-ring seal from the engine oil level sensor.
scientia non olet · About LEMON Manuals