LEMON Manuals: Even more car manuals for everyone
Home >> Land Rover >> 2022 >> Defender 90 S >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 7 (Electronic Engine Controls - V8 S/C 5.0L Petrol -- Defender/L663) >> Electronic Engine Controls - V8 S/C 5.0L Petrol (G2796672) >> Removal And Installation >> Engine Oil Level Sensor (G2796679) >> Installation

Engine Oil Level Sensor (G2796679): Installation

WARNING: This page is about a different variant/trim than selected.
    • Install the new O-ring seal to the engine oil level sensor.

      Renew Part: Oil level sensor O-ring seal(s) Quantity: 1  .

    • Install the engine oil level sensor.
    • Install and tighten the 3 bolts.

      Torque  : 12 Nm 

    • Connect the electrical connector to the engine oil level sensor.
  2. Fill the engine with the correct amount of engine oil.

    Refer to: ENGINE OIL VACUUM DRAINING AND FILLING

  3. Install the engine undershield.

    Refer to: ENGINE UNDERSHIELD

scientia non olet · About LEMON Manuals