LEMON Manuals: Even more car manuals for everyone
Home >> Land Rover >> 2022 >> Defender 90 S >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 7 (Electronic Engine Controls - V8 S/C 5.0L Petrol -- Defender/L663) >> Electronic Engine Controls - V8 S/C 5.0L Petrol (G2796672) >> Removal And Installation >> Crankshaft Position Sensor (G2796676) >> Installation

Crankshaft Position Sensor (G2796676): Installation

WARNING: This page is about a different variant/trim than selected.
  1. CAUTION: Lubricate the O-ring seal with clean engine oil.
    • Install the CKP  .
    • Install and tighten the bolt.

      Torque  : 10 Nm 

    • Connect the electrical connector to the CKP  .
  2. Remove the transmission undershield.

    Refer to: TRANSMISSION UNDERSHIELD

  3. Remove the engine undershield.

    Refer to: ENGINE UNDERSHIELD

scientia non olet · About LEMON Manuals