DTC P0333-22: Knock Sensor 2 Circuit High (Bank 2) - Signal amplitude > maximum: Action
WARNING: This page is about a different variant/trim than selected.
- Vehicle Conditions to enable DTC
Logging Strategy
- Normal driving
- Refer to the electrical circuit diagrams and check knock sensor circuit for short circuit to power
- Measure knock sensor circuit for correct resistance
- Knock sensor resistance should be greater than 4 Mega Ohms
- Inspect connectors for signs of water ingress, and pins for damage and/or corrosion
- Check for abnormal engine noise that may corrupt the knock sensor signal
- Using the Jaguar Land Rover approved diagnostic equipment, clear the Diagnostic Trouble Code(s) and retest
- Install new knock sensor, only when diagnosed as failed