LEMON Manuals: Even more car manuals for everyone
Home >> Land Rover >> 2022 >> Defender 90 S >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (Electronic Engine Controls - INGENIUM I6 3.0L Petrol -- Defender/L663) >> Electronic Engine Controls - INGENIUM I6 3.0L Petrol >> Removal And Installation >> Rear Knock Sensor (G2344550) >> Removal

Rear Knock Sensor (G2344550): Removal

WARNING: This page is about a different variant/trim than selected.
NOTE:
  • This procedure contains some variation in the illustrations depending on the vehicle specification, but the essential information is always correct.
  • This procedure contains illustrations showing certain components removed to provide extra clarity.
  1. Raise and support the vehicle on a suitable 2 post lift.

    Refer to: JACKING AND LIFTING

  2. Disconnect the startup battery ground cable.

    Refer to: 12V SYSTEM DISCONNECT AND CONNECT

  3. Remove the engine undershield.

    Refer to: ENGINE UNDERSHIELD

  4. G14066916Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

    Disconnect the electrical connector.

  5. G14066917Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
    • Release the wiring harness from the clip.
    • Remove the bolt.
    • Remove the knock sensor.
scientia non olet · About LEMON Manuals