LEMON Manuals: Even more car manuals for everyone
Home >> Land Rover >> 2022 >> Defender 90 S >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (Electronic Engine Controls - INGENIUM I6 3.0L Petrol -- Defender/L663) >> Electronic Engine Controls - INGENIUM I6 3.0L Petrol >> Removal And Installation >> Mid Catalyst Heated Oxygen Sensor (G2344552) >> Installation

Mid Catalyst Heated Oxygen Sensor (G2344552): Installation

WARNING: This page is about a different variant/trim than selected.
  1. CAUTION:
    • If accidentally dropped or knocked install a new sensor.
    • Make sure that the sensor tip is clean and free of foreign material.

    Use the special tool to install and tighten the mid catalyst heated oxygen sensor.

    Special Tool(s): JLR-303-1666 

    Torque  : 48 Nm 

    • Connect the electrical connector.
    • Install the wiring harness into the clip.
  3. Install the noise, vibration and harshness material into the correct location.
  4. Install the transmission undershield.

    Refer to: TRANSMISSION UNDERSHIELD

scientia non olet · About LEMON Manuals