Intake Camshaft Position Sensor (G2344548): Installation
WARNING: This page is about a different variant/trim than selected.
-
- Lubricate the O-ring seal with clean engine oil.
Refer to: SPECIFICATIONS
- Release the Noise, Vibration and Harshness (NVH) material.
- Install the intake camshaft position sensor.
- Install and tighten the bolt.
Torque : 8 Nm
- Lubricate the O-ring seal with clean engine oil.
-
- Connect the electrical connector.
- Install the NVH material.
- Install the engine cover.
Refer to: ENGINE COVER - INGENIUM I6 3.0L PETROL
- Connect the startup battery ground cable.
Refer to: 12V SYSTEM DISCONNECT AND CONNECT