Exhaust Camshaft Position Sensor (G2344546): Installation

WARNING: This page is about a different variant/trim than selected.

- Lubricate the O-ring seal with clean engine oil.
  Refer to: SPECIFICATIONS
- Install the exhaust camshaft position sensor.
- Install and tighten the bolt.
  Torque : 8 Nm
- Connect the electrical connector.
- Install the Noise, Vibration and Harshness (NVH) material.
Install the engine cover.
Refer to: ENGINE COVER - INGENIUM I6 3.0L PETROL
Connect the startup battery ground cable.
Refer to: 12V SYSTEM DISCONNECT AND CONNECT