Engine Coolant Temperature Sensor (G2416602): Installation
WARNING: This page is about a different variant/trim than selected.
- CAUTION:
- Make sure that the mating surfaces are clean and free from debris and foreign material.
- Make sure that the clip is correctly located.
- Install the new O-ring seal.
Renew Part: Coolant temperature sensor O-ring seal Quantity: 1 .
- Install the Engine Coolant Temperature (ECT) sensor.
- Install the ECT sensor clip.
- Connect the electrical connector to the ECT sensor.
- Install the air filter housing.
Refer to: AIR FILTER HOUSING
- Install the air filter outlet pipe.
Refer to: AIR FILTER OUTLET PIPE
- Install the BISG
.
Refer to: BELT INTEGRATED STARTER GENERATOR
- Fill the engine cooling system with the correct amount of engine coolant.
Refer to: COOLING SYSTEM PARTIAL DRAINING AND VACUUM FILLING