Cylinder Head Temperature Sensor (G2344551): Installation

WARNING: This page is about a different variant/trim than selected.

CAUTION: Make sure all the mating faces are clean and free from foreign material.
- Use the special tool to install and tighten the new cylinder head temperature sensor.
  Special Tool(s): 303-680
  
  Torque : 10.5 Nm
- Connect the electrical connector.
Install the Noise, Vibration and Harshness (NVH) material.
Install the engine cover.
Refer to: ENGINE COVER - INGENIUM I6 3.0L PETROL