LEMON Manuals: Even more car manuals for everyone
Home >> Land Rover >> 2022 >> Defender 90 S >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (Electronic Engine Controls - INGENIUM I6 3.0L Petrol -- Defender/L663) >> Electronic Engine Controls - INGENIUM I6 3.0L Petrol >> Removal And Installation >> Center Knock Sensor (G2328039) >> Installation

Center Knock Sensor (G2328039): Installation

WARNING: This page is about a different variant/trim than selected.
    • Install the knock sensor.
    • Install and tighten the bolt.

      Torque  : 20 Nm 

    • Install the 2 clips.
    • Connect the wiring harness electrical connector.
  3. Install the oil cooler.

    Refer to: OIL COOLER

  4. Connect the startup battery ground cable.

    Refer to: SPECIFICATIONS

scientia non olet · About LEMON Manuals