Adaptive Speed Control Module - Vehicles With: SVR (G2271674): Removal
WARNING: This page is about a different variant/trim than selected.
WARNING:
The customer must be informed that in the first 2 hours of driving, the Cruise Control Module (CCM) will continue to self calibrate. CCM
may not be available and full system performance may not be achieved.
CAUTION:
- Make sure that there is no modification on the CCM before its installation to the vehicle.
- The CCM assembly must not be disassembled or pre-adjusted before installation.
- If accidentally dropped to the ground, the CCM must not be installed.
- The CCM must be handled carefully as damage may cause water ingress into the module.
- The CCM is equipped with a pressure equalization membrane located under the type label. Damage can affect the water tightness of the module.
NOTE:
- This procedure contains some variation in the illustration depending on the vehicle specification, but essential information is always correct.
- This procedure contains illustrations showing certain components removed to provide extra clarity.
- Disconnect the startup battery ground cable.
Refer to: SPECIFICATIONS
- Raise and support the vehicle on a suitable 2 post lift.
Refer to: JACKING AND LIFTING
- Remove the front bumper.
Refer to: FRONT BUMPER
- Disconnect the electrical connector.
- Remove the CCM .