Adaptive Speed Control Module Adjustment - Vehicles With: SVR (G2271673): Adjustment

WARNING: This page is about a different variant/trim than selected.

NOTE: The park brake icon may hide the follow icon until it is released.
- Connect the Jaguar Land Rover diagnostic tool.
  General Equipment: Jaguar Land Rover approved diagnostic equipment
- From the diagnostic tool menu, select: Service Alignment Mode.
- The follow indicator will now be flashing, this indicates that the vehicle is in 'service alignment' and now requires driving.
- The vehicle speed must be above 25 mph (40 kph).
- Choose a road with plenty of stationary objects, like street lights, parked cars, road signs, or barriers. Use an inside or outside lane.
- Following vehicles too closely will obscure the stationary objects from the radar, a time gap of 2 seconds is recommended.
- A straight road will produce a quicker and better result, although the process will still operate on a curved road.
- When the flashing follow indicator light extinguishes, initial alignment is complete. The adaptive speed control system will continue to refine the alignment.
- Check that the adaptive speed control can now be engaged.
- If the adaptive speed control can be engaged, no further driving is required.
- If the adaptive speed control can not be engaged, using the diagnostic tool, repeat the service alignment mode.
  General Equipment: Jaguar Land Rover approved diagnostic equipment
- If the adaptive speed control can still not be engaged after the second attempt, remove the front bumper and check the installation of the adaptive speed control module. Repeat step 1 once the installation has been corrected.