Starter Motor (G2796642): Removal

WARNING: This page is about a different variant/trim than selected.

NOTE:

This procedure contains some variation in the illustrations depending on the vehicle specification, but the essential information is always correct.
This procedure contains illustrations showing certain components removed to provide extra clarity.

Raise and support the vehicle on a suitable 2 post lift.
Refer to: JACKING AND LIFTING
Disconnect the 12 V system.
Refer to: 12V SYSTEM DISCONNECT AND CONNECT
Remove the engine undershield.
Refer to: ENGINE UNDERSHIELD
Remove the transmission undershield.
Refer to: TRANSMISSION UNDERSHIELD
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
- Remove the 2 bolts.
- Remove the heatshield from the starter motor.
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
- Reposition the positive cable shield as illustrated.
- Remove the nut.
- Release the positive cable from the starter motor.
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Disconnect the starter motor electrical connector.
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
- Release the breather pipe clip.
- Disconnect the 2 breather pipe connectors.
- Reposition the breather pipe assembly away from the starter motor.
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
- Remove the 3 bolts.
- Remove the starter motor bracket.
NOTE: Note the different lengths of the bolts.

Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
- Remove the 2 starter motor bolts.
- Remove the starter motor as illustrated.
NOTE:
- Do not disassemble further if the component is removed for access only.
- Note the position of the cable.
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Loosen the nut and remove the cable from the starter motor.