LEMON Manuals: Even more car manuals for everyone
Home >> Land Rover >> 2022 >> Defender 90 S >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 30 (Starting System - V8 S/C 5.0L Petrol -- Defender/L663) >> Starting System - V8 S/C 5.0L Petrol >> Diagnosis And Testing >> Starting System - V8 S/C 5.0L Petrol (G2847134) >> Auto Stop/Start System Inhibits

Auto Stop/Start System Inhibits

WARNING: This page is about a different variant/trim than selected.

The inhibit conditions listed below will not set a DTC  but will set flags which can be viewed using the Jaguar Land Rover approved diagnostic equipment - Datalogger/Powertrain Control Module (PCM). Normal Auto Stop/Start system operation will resume when an inhibit condition is no longer present, but the battery related inhibits may persist for some time.

NOTE:
  • Performing a DTC  clear on a petrol (gas) engine vehicle will inhibit the auto stop/start system.
  • Do not reset the Battery Monitoring Sensor (BMS) to rectify battery condition inhibits. This may temporarily restore the auto stop/start system operation but will lead to a recurrence of the fault.
INHIBITS
  • Auto stop/start switch has been pressed by driver
  • DTC  clear performed
  • Transmission cannot support an engine stop
  • Accelerator pedal not released
  • Hood open detected
  • Driver door detected open
  • Driver seatbelt not fastened
  • Hill Descent Control (HDC) is switched on
  • Terrain response special program selected
  • Transmission is in low range
  • Climate control demand exceeds calibrated threshold
  • Heated windshield operating
  • Trailer connected
  • Engine coolant temperature below threshold
  • Engine oil temperature below threshold
  • Catalytic converter outside either pre or post calibration range
  • Battery state of charge low
  • Battery cold cranking capability below threshold
  • Ambient temperature above 40°C
  • Ambient temperature below -5°C
  • Fuel tank level is low (Approximately 6 liters or less remaining in the fuel tank)