DTC P0196-2A: Engine Oil Temperature Sensor "A" Range/Performance - Signal stuck in range: Action
WARNING: This page is about a different variant/trim than selected.
- Vehicle Conditions to enable DTC
Logging Strategy
- Start and drive vehicle at steady state, low load condition for 20 minutes
- Prioritized Checks to Perform
- Using the Jaguar Land Rover approved diagnostic equipment check datalogger signals
- Engine Oil Temperature (0xF45C)
- Engine Oil Pressure - Raw (0x0415)
- Throttle Position Sensors Learned Offsets With Statuses (0x045C)
- Engine Oil Temperature (0xF45C)
- Sump Oil Temperature - Measured (0x03F3)
- Engine Oil Level - Measured (0x03E6)
- Inspect connectors for signs of water ingress, and pins for damage and/or corrosion
- Refer to the electrical circuit diagrams and check the oil pressure and temperature sensor circuit for
- Fuse failure
- Short circuit to ground
- Short circuit to power
- Open circuit
- High resistance
- Install new oil pressure and temperature sensor, only when diagnosed as failed
- Using the Jaguar Land Rover approved diagnostic equipment, clear all stored Diagnostic Trouble Code(s) and retest