Possible Causes
WARNING: This page is about a different variant/trim than selected.
- Electrical Cause
- Yes
- Mechanical Cause
- No
- Control Module Cavity
- Circuit reference I_A_IATS
- Purpose of the DTC
- Monitor sensor for excessive drift compared to other sensors
- Component
- TMAF A
- Prioritized List of Possible Causes
- Intake air temperature sensor signal is higher than expected
- Connector is disconnected, connector pin is backed out, connector pin corrosion
- Harness failure - Wiring integrity short circuit to ground, short circuit to power, open circuit, high resistance