DTC P0106-23: Manifold Absolute Pressure/Barometric Pressure Sensor Circuit Range/Performance - Signal stuck low: Action
WARNING: This page is about a different variant/trim than selected.
- Vehicle Conditions to enable DTC
Logging Strategy
- Ignition on if engine has been off for greater than 5 seconds on the previous drive cycle
- Prioritized Checks to Perform
- Using the Jaguar Land Rover approved diagnostic equipment check datalogger signal
- Manifold Absolute Pressure - High Resolution (0x0370)
- Refer to the electrical circuit diagrams and check the intake manifold TMAP sensor (manifold pressure) circuit for short circuit to ground, short circuit to power, open circuit, high resistance
- Inspect connectors for signs of water ingress, and pins for damage and/or corrosion
- Install new intake manifold TMAP sensor (manifold pressure), only when diagnosed as failed
- Using the Jaguar Land Rover approved diagnostic equipment, clear all stored Diagnostic Trouble Code(s) and retest