Coolant Pump (G2796608): Installation

WARNING: This page is about a different variant/trim than selected.

Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
- Install the 2 brackets.
- Install the clip.
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
- Install the supercharger coolant pump.
- Install and tighten the bolt.
  Torque : 7 Nm
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
- Install the 2 coolant hoses.
- Install the 2 clamps.
- Install the coolant hose clip.
- Connect the electrical connector.
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
- Install the coolant hose.
- Connect the coolant hose connector.
- Install the coolant hose to the transmission fluid cooler.
- Install the clamp.
- Install the 2 coolant hose clips.
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Connect the coolant hose connector.
Install the windshield washer reservoir.
Refer to: WINDSHIELD WASHER RESERVOIR - V8 S/C 5.0L PETROL
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
- Connect the coolant hose connector.
- Connect the electrical connector.
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
- Install the left clean air duct.
- Tighten the clamp.
  Torque : 3.5 Nm
Install the air cleaner outlet pipe t-connector.
Refer to: AIR CLEANER OUTLET PIPE T-CONNECTOR
Fill the engine cooling system with the correct amount of coolant fluid.
Refer to: COOLING SYSTEM PARTIAL DRAINING AND VACUUM FILLING
Connect the 12V system.
Refer to: 12V SYSTEM DISCONNECT AND CONNECT