Front Electric Cooling Fan (G2818257): Removal
WARNING: This page is about a different variant/trim than selected.
CAUTION:
- The desiccant bag need only be changed under the following circumstances: There is dirt in the refrigerant circuit (For example: compressor seizure), the system is leaking and refrigerant has been lost to atmosphere, or the refrigerant circuit has been open more than 24 hours, due to repair.
- Before disconnecting any components, make sure the area is clean and free from foreign material. When disconnected all openings must be sealed.
NOTE:
- This procedure contains some variation in the illustrations depending on the vehicle specification, but the essential information is always correct.
- This procedure contains illustrations showing certain components removed to provide extra clarity.
- Disconnect the 12V system.
Refer to: 12V SYSTEM DISCONNECT AND CONNECT
- Raise and support the vehicle on a suitable 2 post lift.
Refer to: JACKING AND LIFTING
- Remove the cooling module.
Refer to: COOLING MODULE
-
CAUTION: Take extra care not to damage the component.
- Release the electric cooling fan wiring harness clip.
- Remove the cooling module air deflector at the 6 clips.
- Release the clamp.
- Release the 2 coolant pipe clips.
- Remove the coolant pipe.
-
CAUTION: Take extra care not to damage the component.NOTE: Note the position of the locating pegs prior to removal.
- Remove the 2 bolts.
- Remove the electric cooling fan at the 2 clips.