LEMON Manuals: Even more car manuals for everyone
Home >> Land Rover >> 2022 >> Defender 90 S >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 21 (Accessory Drive - INGENIUM I6 3.0L Petrol -- Defender/L663) >> Accessory Drive - INGENIUM I6 3.0L Petrol >> Diagnosis And Testing >> Accessory Drive - INGENIUM I6 3.0L Petrol (G2400964) >> Inspection And Verification

Inspection And Verification

WARNING: This page is about a different variant/trim than selected.
CAUTION:
  • If the engine is run without the drive belt(s) connected to eliminate driven components, diagnostic trouble codes may be set which must be cleared before the vehicle is returned to the owner. The engine should not be run for more than 2 minutes with the belts disconnected. Failure to follow this instruction may result in damage to the vehicle.
  • Diagnosis by substitution from a donor vehicle is NOT  acceptable. Substitution of control modules does not guarantee confirmation of a fault, and may also cause additional faults in the vehicle being tested and/or the donor vehicle.
NOTE:
  • If a control module or a component is at fault or may be at fault and the vehicle remains under manufacturer warranty, refer to the Warranty Policy and Procedures manual, or determine if any prior approval program is in operation, prior to the installation of a new module/component.
  • When performing voltage or resistance tests, always use a digital multimeter that has the resolution ability to view 3 decimal places. For example, on the 2 volts range can measure 1 mV or 2 kΩ range can measure 1 Ω. When testing resistance always take the resistance of the digital multimeter leads into account.
  • Check and rectify basic faults before beginning diagnostic routines involving pinpoint tests.
  1. Verify the customer concern
  2. Visually inspect for obvious signs of damage and system integrity
    VISUAL INSPECTION DESCRIPTION

    MECHANICAL
    • Viscous cooling fan pulley
    • Belt integrated starter generator drive belt tensioner
    • Belt integrated starter generator
    • Belt integrated starter generator drive belt
    • Air conditioning (AC) compressor
    • Coolant pump
    • Idler pulley
    • Crank shaft pulley/Torsional mass damper
    • Viscous cooling fan drive belt
  3. If an obvious cause for an observed or reported concern is found, correct the cause (if possible) before proceeding to the next step
  4. If the cause is not visually evident, verify the symptom and refer to the Symptom Chart, alternatively check for Diagnostic Trouble Codes (DTCs) and refer to the DTC Index
  5. Check JLR claims submission system for open campaigns. Refer to the corresponding bulletins and SSMs which may be valid for the specific customer complaint and complete the recommendations as required
scientia non olet · About LEMON Manuals