LEMON Manuals: Even more car manuals for everyone
Home >> Land Rover >> 2022 >> Defender 90 S >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 18 (Battery, Mounting And Cables - Vehicles With: MHEV -- Defender/L663) >> Battery, Mounting And Cables - Vehicles With: MHEV >> Removal And Installation >> MHEV Pass Through Assembly - 90 (G2886131) >> Installation

MHEV Pass Through Assembly - 90 (G2886131): Installation

WARNING: This page is about a different variant/trim than selected.
    • Install the MHEV  pass through assembly.
    • Install and tighten the 4 bolts.

      Torque  : 10 Nm 

    • Connect the underside electrical connector.
    • Install the wiring harness into the clip.
  3. Connect the loadspace electrical connector.
  4. Install the rear subframe.

    Refer to: REAR SUBFRAME

  5. Install the second row seat.

    Refer to: SECOND ROW SEAT - 90, BENCH TYPE

  6. Power up the MHEV  system.

    Refer to: MHEV POWER DOWN/UP 

scientia non olet · About LEMON Manuals